Air suspension FIAT DCUATO/Citroen Jumper/Peugeot Boxer 30/33/35, type 250/290/Y, year of manufacture 04.06.. + facelift from 05.14..

Article number:

AIRSUS-FD-250-290-B

Air suspension for FIAT DCUATO/Citroen Jumper/Peugeot Boxer 30/33/35, type 250/290/Y, built 04.06.. + facelift from 05.14..

1 set of additional 8-inch air springs for the rear axle to reinforce the standard leaf springs. The air suspension is installed between the frame and the axle.

Whether hard or soft suspension, high or low vehicle height, the vehicle can be adjusted to the driver's requirements by changing the air pressure. The air suspension raises or lowers the rear of the vehicle to the standard height, regardless of the load. Either with the tire inflator during a stop at the gas station or with the built-in compressor (optional).

Advantages

• Better suspension behavior thanks to increased suspension travel.
• Lower sensitivity to crosswinds.
• Improved road holding.
• Maximum height gain at maximum load.
• Shorter braking distance thanks to optimized brake pressure.
• Lower tire wear.
• Production and development in accordance with ISO 9001 and TÜV requirements.

The kit is supplied with a parts certificate from RWTÜV Essen. Proper installation must be confirmed by an approved testing organization.

Special features:

- For vehicles with single and double leaf springs

- Also for e-Jumpers (electric and hybrid), but not for SmartAir

- Compressor kit variant with dual-circuit system for vehicles without electric handbrake and compressor kit variant with dual-circuit system for vehicles with electric handbrake

- Not for vehicles with standard air suspension, AL-KO rear axle, load-dependent brake pressure regulator on axle 2, and level control

The air suspension consists of 2 x 8-inch double bellows:

The double bellows are used in most of our air springs. Fully adjustable, they keep the vehicle comfortable and safe on the road, regardless of load and road conditions. They require no minimum pressure and have very good emergency running properties. When fully compressed, it acts as a stop limiter. Thanks to its high performance and safety reserves, our double bellows can be used either as additional air suspension (used in these springs) or as full air suspension, completely replacing the standard chassis.

It can be ordered in the following versions:

1. Basic: Consists of additional mounting material (air hose, T-pieces, etc.) and a panel with 2 filling valves for filling with a tire inflator.
2. Compressor kit dual-circuit system: Consists of additional mounting material (air hose, T-pieces, etc.), a 45-liter compressor, and a vehicle-specific double cab control panel, which allows the air springs to be conveniently operated from the cab. Both bellows can be filled independently of each other up to the maximum pressure and emptied again to the minimum pressure. This has the advantage that different loads can be balanced and the vehicle always remains stable when cornering.
3. as 2. but specially designed for vehicles with electric handbrakes. Control panel on the driver's seat
4. SmartAir (automatic level control): Consists of additional mounting material (air hose, T-pieces, etc.), a 70-liter high-performance compressor, and a height sensor. This system automatically maintains your vehicle at the optimum height, regardless of whether it is loaded or unloaded.